Electronic scale Load Cell replacement Operation Steps

The steps for replacing the sensor of the electronic scale are as follows:

1: Open the top cover of the sensor (damaged), lift the weighing platform with a jack, and remove the load cell ground wire.

2: Open the junction box and release the damaged sensor cable from the junction box. Pull out the cable at the weighing loadc cell end. Note: When pulling the wire, attach a lead wire to pass through the scale body so that when a new load cell is replaced, the cable wire passes through the scale body and enters the junction box.

3: Refer to the second method above, and pass the weighing sensor cable through the scale body into the junction box.

4: According to the wiring diagram, fix each core wire of the cable on the corresponding terminal of the junction box.

5: Loosen the jack, level the weighing platform, and cover the cover.

6: After replacing the weighing load cell sensor, the truck scale must be reset and calibrated.

7: After the weighing load cell sensor is installed, the excess cables should be bundled and placed, not directly on the foundation ground.

8: In order to ensure the consistency and interchangeability of the sensor, the sensor cable shall not be cut off at will.

9: During installation and disassembly, no scratches or bumps on the sensor should occur, and the cables should be protected.

Want to know more products please visit our website: www.cranescaleloadcell.com , please feel freely contact with us: saintbond@saintbond.com, Please contact us: Mobile/WhatsApp/WeChat/ LinkedIn:+86-18868650852, We can sincerely hope we can Provide more valuable services!