Tel.:   +86-574-86902685
Mobile/WeChat/WhatsApp: +86-13186894933
High Quality Products Can Be Purchased.

Connection method of loadometer sensor:

Views: 0     Author: Annis from Saintbond company     Publish Time: 2022-08-27      Origin: www.cranescaleloadcell.com

Connection method of loadometer sensor:
Loadometer sensors generally use bridge QS sensors, but also column and cantilever beams. Generally, 4-8 sensors are collected in the junction box, and then connected to the instrument by a main line. Sensors of different manufacturers should be connected according to the instructions. The sensor wires made by different manufacturers are of different colors. The four wires are positive and negative excitation and positive and negative signals. Generally, the color of the sensor line is divided into red and black, green and white. Red, black, green and white: Red, white, green, and blue equal sub-marks indicate that V+, V-, S+, and S- are connected to the junction box in turn. According to the structure and distribution of the weighing platform, connect to the junction box 1,2,3,4,5,6,7,8 and label. This is convenient for maintenance.
There are two ways to wire out the load cell: 4-wire and 6-wire. There are also 4-wire and 6-wire wiring for the module or weighing transmitter. Whether to connect 4-wire or 6-wire depends on your hardware requirements. , The principle is: the sensor can be connected to 6 wires but not 4 wires, and the sensors that must be connected to 4 wires must be shorted.
The general load cell is a six-wire system. When connected to a four-wire system, the power line (EXC-, EXC+) and the feedback line (SEN-, SEN+) are short-circuited respectively. SEN+ and SEN- are used for compensating circuit resistance. SEN+ and EXC+ are connected, and SEN- and EXC- are connected. EXC+ and EXC- supply power to the load cell, but due to the line loss between the weigh module and the sensor, the voltage received by the sensor will actually be less than the supply voltage. Each load cell has a characteristic of mV/V. The mV signal it outputs is closely related to the received voltage. SENS+ and SENS- are actually a high-impedance loop in the load cell. The received voltage is fed back to the weighing module. Assuming that EXC+ and EXC- are 10V, the line loss, the sensor is 2mV/V, in fact the maximum signal output by the sensor is ()*2=19mV instead of 20mV. At this time, the load cell will use 19mV as the maximum range, provided that the sensor must feed back the actual voltage to the weighing module through a feedback loop. Short-circuit EXC+ and SENS+, and short-circuit EXC- and SENS- on the load cell. This is limited to occasions where the distance between the sensor and the weighing module is short and the voltage loss is very small, otherwise there will be errors in the measurement.

Home

Contact Us

Web: www.saintbond.com      
E-mail: saintbond@saintbond.com  
Tel.: +86-574-86902686
Mobile/WeChat/WhatsApp: +86-13186894933
Follow us on social networks!
Copyrights 2003-2030 Ningbo SAINTBOND Electronic Co.,Ltd.   Sitemap