The working principle of the metering color masterbatch machine:

When the color masterbatch fails, you don't have to be nervous. First, find out where the problem is, and then prescribe the right medicine to solve the problem and use it normally.

The working principle of the metering color masterbatch machine: the signal from the control box is transmitted to the motor, the motor starts to rotate, and the screw rotates through the coupling. The color masterbatch in the hopper falls into the falling rod, is squeezed by the screw, and is transported to the base by the screw, so as to achieve the purpose of metering and conveying the color masterbatch.

The debugging method of the metered color masterbatch machine and the test operation process of the metered color masterbatch machine:

1. Turn on the secondary power switch after the control box;

2. What color pipe is to be produced, press the "Set" button twice to enter the "Working Parameters" internal parameters, and change the screw number to the corresponding color.

01, then change the corresponding number after the screw number to 01 and press the "Set" key to save. Press the "Stop" key twice to return to the page ready to run.

3. Press the green button to display "Ready" in the lower left corner of the text of the controller. At this time, the host starts up and the display in the lower left corner of the text of the speed controller with a speed of more than 5 rpm changes from "Ready" to "Running".

4. When the yellow light is flashing, the lower left corner of the controller's text displays "running" and changes to "stop when material is lacking", indicating that the material level in the hopper is lower than the detected position, indicating that the masterbatch needs to be added.

5. When the red light flashes and the thermal relay controlling the stirring motor is overloaded, please check whether the current of the thermal relay is adjusted too small, or the stirring shaft is wrapped around a lot of belts or the motor is short-circuited.

6. Operation of the buttons of the controller

Up arrow: invalid in the non-setting stop state, positioning to the previous parameter in the setting state, and adding operation of the current bit in the modifying parameter state

Down arrow: invalid in the non-setting stop state, positioning to the next parameter in the setting state, and subtracting the current bit in the parameter modification state